[Lazarus] MacOS 10.5 - Compiling a package stops without error message

Roland Turcan konf at rotursoft.sk
Tue Jul 22 10:54:10 CEST 2008

Hello folks,

MG> Since svn rev 15749 lazbuild can do that:
MG> ./lazbuild --build-ide=
MG> Mattias

Thanks Mattias, it shows me next ugly error messages during building
lazarus with our components.

How can I turn on move verbose outputs to see more about the problem.

The strangest is, the same source code is buildable into Lazarus/Linux
without any problem, but Linux runs on i386 and MacOS on PPC. I guess
it is problem with compiler.

Assembling resconf
An unhandled exception occurred at $00148A30 :
EAccessViolation : Access violation
  $00Fatal: Compilation aborted

TExternalToolList.Run Exception: there was an error
ERROR: tool reported error


<<< 19.7.2008 11:58 - Mattias Gärtner "nc-gaertnma at netcologne.de" >>>
MG> Zitat von Roland Turcan <konf at rotursoft.sk>:

>> Hello lazarus at lazarus.freepascal.org!
>> When I try to compile my package with visual components using
>> makefile, then compilation and linking successfully finishes.
>> When I try to compile from IDE, then compilation stops on one unit
>> (always the same) without any message with reason and IDE gets
>> unstable. The last message is "... Hint: Parameter "s" is not used".
>> no error nothing. The caption of lazarus doesn't have "...compiling".
>> It looks, that compilation finished.
>> How can I build Lazarus with my package from command prompt?

MG> Since svn rev 15749 lazbuild can do that:
MG> ./lazbuild --build-ide=
MG> Mattias

MG> _______________________________________________
MG> Lazarus mailing list
MG> Lazarus at lazarus.freepascal.org
MG> http://www.lazarus.freepascal.org/mailman/listinfo/lazarus

Best regards, TRoland

More information about the Lazarus mailing list