[Lazarus] Switching projects causes Access Violation

[Mattias Gaertner]

On Tue, 25 Sep 2012 14:23:22 +0100
Graeme Geldenhuys <graeme at geldenhuys.co.uk> wrote:

> Hi,
> 
> I'm using Lazarus 1.1 LCL-GTK2 64-bit under Linux.
> 
>      Lazarus 1.1 r38729 FPC 2.6.0 x86_64-linux-gtk 2
> 
> Every now and again, if I switch between projects, then Lazarus IDE 
> throws and Access Violation with the dialog warning about data loss and 
> the usual OK or Cancel button.

Can you see a pattern?

 
> I ran Lazarus from the command line and used the IDE until I got that 
> error again - it didn't take long. Only recently did I start using the 
> Anchor Docking add-on, but I can't remember if this issue occurred 
> before I used Anchor Docking. 

I use that too and saw the above thing too.
I did not yet have the time to investigate.


>[...]
> I don't know where the issue is... IDE, Anchor Docking, Project 
> Inspector window etc. But just it case, my anchor docking layout is as 
> follows.
> 
> +----------------------------------------------------+
> |                                                    |
> |            main IDE form                           |
> +----------------------------------------------------+
> |           |                                        |
> |           |                                        |
> |           |                                        |
> |  Project  |                                        |
> | Inspector |                                        |
> |  window   |      Editor window                     |
> |           |                                        |
> |           |                                        |
> |           |                                        |
> |           +----------------------------------------+
> |           |                                        |
> |           |      Message window                    |
> |           |                                        |
> +-----------+----------------------------------------+

Pretty normal.


Mattias